用这个DIY国旗在7月4日七月4日到家里。它真的很容易和一个伟大的项目与孩子们一起做.8块棋盘，矿山是1“x3”x36“，但如果你有它们，你也可以使用旧的2”x4“或栅栏或托盘板铺设。真的仿古板看起来很棒.-2码2米宽织带 - 2扣 - 一张海报板 - 油漆（呃，红色，白色和蓝色），我用喷漆因为我很懒那but brush on paint would be fine too.- Staple gun- SandpaperSTEPSPaint two of your boards red and one white.On the remaining three boards, apply masking tape at around the 16" mark and paint that portion blue. Once dry, remove the tape and using new tape, mask off the blue area and paint the non-painted part on two boards white and one board red. If you're spray painting, lay a piece of cardboard over the blue part to keep the spray from getting on it. Once dry, remove the tape.Cut a star template out of your poster board using a utility knife. It's easiest to take the time to trace one of the wood boards onto the poster board and then measure and cut out 6 stars all in a line within the traced lines. Then just line up the trace marks with the actual boards and spray paint all six stars at once.Use a piece of sandpaper to soften the edges of your boards and let some of the wood underneath show through. Focus on the edges and the corners, but you can also take some of the paint off the flat area if your want a more weathered look.Cut the two yards of webbing into two 36" pieces and add a grommet to one end of each piece. If you've never grommeted before, you can get the kits at any fabric or craft store and it's actually a lot of fun, you'll want to grommet everything in sight! Lay your boards face down in a flag formation and lay the webbing down each side, 6" in from the edge, and attach with a staple gun. Use a staple at the top and bottom of each board to keep the boards from tilting.Hang and salute!